Descargar Imprimir esta página

SPORTSTECH sWalk Plus Manual De Usuario página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6. Troubleshooting
Problem
Device does not switch
on or does not start
Running belt slips
Running belt faltering
during use
Running belt not
centred
In all cases of doubt, contact our customer service. You find the contact details on the last page.
7. Cleaning and maintenance
7.1 CLEANING
After each use, wipe sweat from the device with a slightly wetted cloth.
Never allow moisture or humidity to reach the computer or other electrical or electronic components.
Do not use abrasives or solvents.
7.2 MAINTENANCE
Before and after each training session, check that the device is in perfect condition. Also check that
all fastening parts and protective covers are in place and intact. Tighten bolts and nuts if necessary.
7.3 LUBRICATING
For proper functioning and long life of the device, the running belt must be adequately lubricated with
silicone oil. There are thin tubes on the underside of the device as a lubrication system.
7.3.1 Lubrication and inspection intervals
Refill with silicone oil after the first 25 hours of operation (or 2-3 months).
Check the lubrication regularly.
Top up with silicone oil at least every 50 operating hours (or 5-8 months).
Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
7.3.2 Checking lubrication
Make sure that the electrical supply plug of the device is disconnected.
Lift the running belt on one side. Run your finger over the top of the running deck under the running
belt.
- If the running deck feels slightly oily, the lubrication is sufficient
- However, if the running deck feels dry, you need to top up with silicone oil.
Possible reason
Power cable not plugged in
Safety Tether Key is not
correctly installed
Circuit breaker in the
house has been tripped
Treadmill circuit breaker
has been tripped.
Running belt not tightened enough
Running belt not lubricated enough
Running belt too tight
Running belt unevenly tensioned
Possible solution
Plug in the power cable
Reinstall the Safety Tether Key
Reset the circuit breaker, or call
an electrician to replace the
circuit breaker
Wait 5 minutes and then try to
restart the treadmill
Adjust belt tension
Refill silicone oil
Relax the running belt
Adjust the running belt centrally
DE
EN
37

Publicidad

loading