Futurelight EVO-7 Lighting effect Manual Del Usuario página 26

OPERATION
After you connected the effect to the mains, the EVO-7 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.
Stand Alone operation
In the Stand Alone mode, the EVO-7 can be used without controller. You can do without a controller as the
EVO-7 features a built-in microphone, which provides automatic sound control.
Disconnect the EVO-7 from the controller and set the DIP-switch 10 to On.
The lamp is automatically ignited as soon as the condensor microphone receives music signals.
Call up the Auto program
In order to call up the Auto program, set all DIP-switches to Off.
Master/Slave-operation
Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.
Auto Program MIC SENSITIVITY-button
1. Put the Dip-switch in the sound mode and adjust the sensitivity of the activated sound by turning the MIC
SENSITIVITY-button.
2. In the Auto Program mode (all Dip-switches to OFF) you can select different internal programs with this
button.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
DMX-protocol
Control channel 1 – Colour-wheel
Decimal Hexad. Percentage S/F
0 127 00 7F 0% 50%
128 187 80 BB 50% 73%
188 193 BC C1 74% 76%
194 255 C2 FF 76% 100%
Control channel 2 – Prism rotation
Decimal Hexad. Percentage S/F
0 7 00 07 0% 3%
8 127 08 7F 3% 50%
128 135 80 87 50% 53%
136 255 88 FF 53% 100%
S Gobo indexing
F Forwards rainbow effect with decreasing speed
S No rotation
F Backwards rainbow effect with increasing speed
S No rotation
S Forwards gobo-rotation with decreasing speed
S No rotation
S Backwards gobo-rotation with increasing speed
26/55
Feature
Feature
51837560_V_1_4.DOC