Progress Lighting P250105 Manual De Instrucciones página 10

Attaching the Fan Blades
Attach the fan blades to the motor. Align the holes
in the blade support plate, blade and the fan motor
assembly and secure with the screws and lock
washers. (Fig. 13)
Figure 13
7. Installing the Light Kit
CAUTION: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at the fuse box. Turning power
off using the fan switch is not sufficient to prevent
electric shock.
Step 1. While holding the 20W LED light kit
under the fan motor assembly, snap together the
wire connection plugs :
- White to white
- Black to blue
Step 2. Position the notches in the outer rim of
the LED light kit so they line up with the tabs on
the inside of the rim on the light kit mounting
plate. Carefully lift the LED light kit up inside
the light kit mounting plate and secure it to the
fan by turning the LED light kit clockwise until
snug. (Fig. 14)
NOTE: The metal light cover included with your
Blades
fan is an option to replace the light kit in the
event that you prefer not to use the light feature
Blade support
of your fan. The metal light cover is not
plates
Screws
necessary for the light operation; it can be saved
for later use if desired.
Wire connector
LED
light kit
assembly
Metal light
cover
Figure 14
Mounting
plate
Tabs
Notches