Publicidad
Idiomas disponibles
Idiomas disponibles
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$
Do not probe the charger.
u
+
The charger is intended for indoor use only.
Read the instruction manual before use.
#
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains volt-
age corresponds to the voltage on the rating plate.
Never attempt to replace the charger unit with a
regular mains plug.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed wheel
2. Variable speed switch
3. Lock-off button
4. Lock-on button
5. Secondary handle
6. Belt tensioning lever
7. Belt tracking knob
8. Straight arm
9. Battery
10. Battery release
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
(Original instructions)
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first use.
Plug the charger (11) into an appropriate outlet before
u
inserting battery pack (9).
The green charging light (11a) will blink continuously
u
indicating that the charging process has started.
The completion of charge will be indicated by the green
u
charging light (11a) remaining ON continuously. The
battery pack (9) is fully charged and may be removed and
used at this time or left in the charger (11).
Charge discharged batteries within 1 week. Battery life will
u
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
Note: The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note: This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely.
The charger will keep the battery pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, the green LED
(11a) will flash intermittently, while the red LED (11b) will
remain on continuously, suspending charging until the battery
has reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery life.
ENGLISH
9
Publicidad
