Thermador PRD304GHC Manual De Instalación página 11

Gas and Electric Supply Zones
Gas & Electrical Supply Locations for 30"and 36" Dual Fuel Ranges
I[
@
@ @
Range Width
30" or 36" (762 or 914 mm)
GAS & ELECTRICAL SUPPLY ZONE
I
J
i5¼ (146 mm) 30" (762 mm) , 3 .
36" (913 mm) 181/16"(205mm)
187"/16 ''
(468 mm) 5 13/16"(148mm) 4%" (111 mm)
1913/16"(503mm) 8½" (206 mm) 4%" (111 mm)
Gas & Electrical Supply Locations for 48" Dual Fuel Ranges
@
@ @
Range
Width _-
48" (1219 mm)
ELECTRICAL
_ _ GAS ZONE ZONE
11_m)_76mm)_ ,. /.
_---- 4%"--_i i i i .... ,,_\I
,_a JW16 -_
(111 mm) i<-_10¾'_-_. '
(273 mm) '_ (151 mm)
(475 mm)
I
i !
_L
i-
Figure 4: Gas & Electrical Supply Locations for Dual Fuel Ranges
NOTICE:
If not already present, install gas shut-off valve in an
easily accessible location.
Make sure all users know where and how to shut off
the gas supply to the range.
Any opening in the wall behind the appliance and any
opening in the floor under the appliance must be
sealed.
The dual fuel ranges may be connected to the power
supply with a range supply cord kit or by hard-wiring to the
power supply. It is the responsibility of the installer to
provide the proper wiring components (cord or conduit and
wires) and complete the electrical connection as dictated
by local codes and ordinances, and/or the National Electric
Code. The units must be properly grounded. Refer to "Step
6: Electrical Requirements, Connection & Grounding" on
page 15 for details. Canadian models have power cord
supplied.
English 8