Thermador PRD304GHC Manual De Instalación página 27

,
For 48" models with large and small ovens, if door or
handle appears slightly tilted, you may adjust the hinge
receiver by rotating the large Torx-head screw located
directly below the hinge receiver with a T-20 Torx
driver. Rotate each screw respective to its side and
direction the door needs to be adjusted (Figure 27).
Step 9: Placing and
the Range
Leveling Leg Adjustment
Leveling
@ @
@
i
Figure 27: Hinge Receiver Adjustment Screw
Data Rating Label and Wiring Diagram
Locations
Data rating labels contain the model and serial numbers.
They can be found under the front edge of the rangetop,
with oven door open or removed.
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.
Dai
Figure 28: Data Rating Label Location
CAUTION:
The top edges of the range's side panels must be on the
same or higher level as the adjacent countertop. If the
range is operated while at a lower height relative to the
adjacent cabinet, the cabinet could be exposed to
excessive temperatures, causing damage to the cabinet
and countertop (see Figure 30 on page 25).
For proper performance, the range must be level. This is
especially important for all products that have the griddle
feature. Priority should be placed on ensuring that the oven
cavities are also level for optimum cooking performance.
The 30" and 36" models have a total of (4) leveling legs,
one beneath each corner, that are threaded into the cast
aluminum base structure; 48" models have (6).
,
,
Measure the countertop heights first with a tape
measure and add an additional 1/16" - 1/8" (2-3 mm).
Adjust the legs accordingly prior to pushing the range
back to its final location.
Rotate the legs using a 12" (305 mm) adjustable
wrench on the flat sides of each foot.
o ol
,, |
Figure 29: Leveling Legs
3. Progression of the height adjustments should be
alternated proportionally between the four corner legs,
until the top edges of the range's side panels are close
to matching the counter top height.
4. Final height adjustments of the two rear legs take place
before moving the range into its installed position in the
cabinet.
English 24