Thermador PRD304GHC Manual De Instalación página 13

36" 48"
i i i iii ii iii ii iii ii ii ii iii ii Iil Iil
Range Range Range
Shipping Weight
Weight without
packing materials
Without doors,
burner caps, front
kick panel and oven
racks
351 Ibs 371 Ibs
(159 kg) (168 kg)
228 Ibs 270 Ibs
(103 kg) (122 kg)
185 Ibs 221 Ibs
(84 kg) (100 kg)
499 Ibs
(226 kg)
403 Ibs
(183 kg)
318 Ibs
(144 kg)
Table 2: Range Weight
Moving the Range
, CAUTION
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
Due to the weight, a furniture dolly with soft wheels or an
air lift should be used to move this unit. The weight must be
supported uniformly across the bottom.
All ranges are held to the pallet by four (4) bolts. The front
kick panel must be removed to access the bolts in the front
of the pallet.
NOTICE:
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.
,
To remove the kick panel, remove the (2) T-20 Torx
screws located below the lower corners of the oven
cavity at the top corners of the kick panel. Slightly push
panel up then out to lift the kick panel away from the
two projections on the range's cast base.
,
Remove the pallet bolts with (2) ½" (12.7 mm)
wrenches, one to hold bolt at the bottom while the other
is loosening the nut at the top.
\
Figure 7: Removal of the Shipping Bolts
3. Lift range and remove it from the pallet. Use additional
help as required to remove from pallet.
4. Transport the range by dolly close to its final location.
Unit should not be dollied from the front.
5.
,
The range can then be tipped back and supported on
the rear legs while the dolly is carefully removed. THE
FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
• %tep 4: Installing the Anti-Tip Device", "Step 5:
Gas Requirements and Hookup" and %tep 6:
Electrical Requirements, Connection &
Grounding", "Step 7: Backguard Installation
(optional)') before the range is placed in its final
position. For proper performance, the range must
be level. See "Step 9: Placing and Leveling the
Range" on page 24 for leveling instructions.
Reinstall the kick panel removed in Step 1. It is
important that the screws retaining the kick panel
are secure to prevent accidental access to hot
surfaces.
Figure 6: Remove Kick Panel
English 10