Thermador PRD304GHC Manual De Instalación página 12

The range must be connected only to the type of gas
for which it is certified, if the range is to be connected to
propane gas, ensure that the propane gas supply tank is
equipped with its own high pressure regulator in addition to
the pressure regulator supplied with the range (See "Step
5: Gas Requirements and Hookup" on page 13.).
NOTE:
The range is designed for flush installation to the back wall.
For a successful installation, it may be necessary to
reposition the gas supply line and the electrical cord as the
range is pushed back to its final position.
SUGGESTION: This may be accomplished by carefully
pulling on a rope or twine looped around the gas or
electrical supply line as the range is pushed back into
its final installed position.
Electrical Supply
Installation of the range must be planned so that rough-in
of terminal block for the receptacle or conduit connection
will allow maximum clearance to the rear of the unit.
When the power supply cord or conduit is connected to the
mating receptacle or terminal block cover, the combined
plug/receptacle or terminal block cover/conduit connector
should protrude no more than 2" (51 mm) from the rear
wall. See Figure 5.
Power Cord &
Receptacle
2" (51 mm)maximum
when plugged in
Junction Box &
Conduit
2"(51 mm)
maximum
1
Figure 5: Wall Connection
Refer to Figure 11 on page 16 for location of terminal block
on unit. To minimize binding when the unit is connected to
the receptacle or terminal block, orient the receptacle or
conduit connector, and slide back into position.
When using a 240VAC receptacle having its own housing,
it will be necessary to recess the receptacle's housing into
the rear wall. Mount the receptacle securely to a wall stud,
then seal around the receptacle's housing. Follow all local
electrical codes.
NOTE:
Canadian models have power cord supplied with range.
Step 3: Unpacking
the Range
and Moving
, CAUTION
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least
two people must be used in moving the range
to avoid injury and to avoid damage to the
unit or the floor. Rings, watches, and any
other loose items that may damage the unit
or otherwise might become entangled with
the unit should be removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
, CAUTION
Do not use a hand truck or appliance dolly on
the back or front of the unit. Handle from the
side only.
Unpacking the Range
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. The range has an approximate shipping weight as
shown in Table 2 on page 10. It is recommended that
the grates, griddle plate, burner caps and oven racks
be removed to facilitate handling. This will reduce the
weight as shown in Table 2. Do not remove the
griddle assembly,
English 9