Publicidad
Idiomas disponibles
Idiomas disponibles
English
maximal authorised duration of the Boost, such as defined during the
user settings by intervals of 5 minutes (or more quickly by push superior
to 2 seconds) by pressing
and effective for the next Boost . After 1 minute, the Boost count begins and
the time is running, minute by minute .
Note: After 1 minute, you can modify temporarily the duration: it will be
valid only for this active Boost and therefore non-recurring .
The Boost can stop for 2 different reasons:
- An order "Stop" has been sent by your energy manager through the
pilot wire:
The device stops, -- appears . The cursor moves above auto . When the
order Comfort will be sent, the device will be restarted until the count end .
If the ambient temperature reaches the maximal Boost temperature
during the count:
The device switches off but the Boost mode is always active : the count
is always displayed, the Boost symbol and the heating indicator flash on
the display . When the temperature drops under the maximal authorised
temperature, the device will be restarted until the count ends .
• Second press: Boost cancellation
The cursor moves above the previous active mode and the setting
temperatura appears .
11.5 Gauge consumption, energy savings
In the device display, an indicator shows the energy comsumption level
by positioning in front of the colour: red, orenge or green . You can choose
your level of energy usage, depending on the setting temperature . As
the temperature setting increases, the consumption will be higher . The
gauge appears in Auto, Comfort, Eco and Frost protection modes and
whatever the temperature level .
C - Red colour
High Tempe-
Setting teperature
> 22°C
rature level: it
is advisable to
When the setting
significantly re-
temperature is higher
duce the setting
than 22°C
temperature .
and
.This modification will be saved
B - Orange
colour
Average tempe-
teperature ≤ 22°C
rature level: it
When the setting tem-
is advisable to
perature is higher than
slightly reduce
19°C and lower or equal
the setting tem-
perature .
Setting teperature
A - Green colour
When the setting tempe-
Ideal settings .
rature is lower or equal
11.6 Setting the Comfort mode temperature
You can access the Comfort temperature set up from the Auto and
Comfort Modes . It is preset to 19°C . Using
the temperature from 7°C to 30°C by intervals of 0 .5°C .
Note: you can limit the Comfort temperature .
11 .7
Consumption indication accumulated in KWH, energy savings
It is possible to see the estimation of energy consumption in KWH since
the last reset of the energy meter .
• Display of the estimated power consumption
To see this estimation, from Auto, Comfort, Eco or Frost protection mode,
then press
. To exit the display mode of consumption: press
, the device returns automatically in the previous active mode .
• Resetting the energy meter
To reset the energy meter, from Auto, Comfort, Eco or Frost protection
mode, then proceed as follows .
1- Press
.
2- Press simultaneously
resetting the energy meter, press
automatically in the previous active mode .
11.8 Child anti-tamper, keypad lock/unlock
• Keypad lock
To lock the keypad, press and hold the
The padlock symbol
appears on the display, the keypad is locked .
- 28 -
19°C <Setting
to 22°C
≤ 19°C
to 19°C
and
1 2 3 4 5 6 7
and
for more than 5 seconds . To exit
or
, the devices returns
and
buttons for 10 seconds .
3
Cod . 1910000000276 - nv04
you can adjust
or
Publicidad
