Cordivari PLUS Manual De Uso página 32

English
Scheme
Display of the ambient temperature
Boost
Selection of the Auto, Comfort, Eco, Frost
protection modes
Adjustment of the setting temperature
desired and the boost duration
Note: the buttons ,
buttons on the controller .
Operation
Position the remote control toward the infrared receiving window of the
device . Check that there is no obstacle between the remote control and
the infrared receiver to disturb the transmission .
12 . User settings
12.1 Access
Access to the User settings in 3 steps:
From Auto, Comfort, Eco or Frost protection mode:
1
Press for 5
seconds
Information
display
1
, and have the same features as the
2
Information
2
display
1 Press twice
= User settings
3
Press briefly
Setting sequence :
Backlighting → Eco mode temperature lowering-level → Frost protezione
temperature → Comfort setting temperature limits → Maximal Boost duration
→ Maximum ambient temperature → Temperature unit
12.2 Backlight setting
1- Three modes can be set:
= Temporary backlighting: Backlight of the display when a button is pressed
= Non-stop backlighting: Backlight of the display all the time
= In this version, the device will work according to the L1 mode .
L3 mode is the default setting .
Press or
2- Press
Infrared
receiving
window
To exit the user settings, press
12.3 Setting the Eco mode temperature lowering-level
The drop in temperature is set at -3,5°C compared to the set temperature of the
Comfort mode . You can adjust the lowered level from -1°C to -8°C, by intervals
of 0,5°C .
Important: whatever the lowering level set, the Eco setting temperature will
never exceed 19°C .
3- Press or
4- Press
To exit the user settings, press
- 32 -
to choose the setting you require .
to save and move to the next setting .
twice .
to obtain the temperature level you require .
to save and move to the next setting .
twice .
Cod . 1910000000276 - nv04