Publicidad
Idiomas disponibles
Idiomas disponibles
use . The PIN code (Personal Identity Number) is a customisable 4
numbers code . When enabled, it prevents access to the following
settings:
- Selecting the Comfort mode: The access tothe Comfort mode is
forbidden, only the Auto, Eco and Frost protection modes are available
- Minimum and maximum limits of the setting temperature range (the
Comfort temperature modification is forbidden out of the authorised
setting range) .
- Programming mode
- Open window detection settings .
- Setting the Eco mode temperature lowering-level .
- Setting the Frost protection temperature
3 important steps are needed for the first use of the PIN code lock:
1 - PIN code initialisation, enter the preset PIN code (0000) to access
the feature .
2 - Activation of the PIN code, to lock settings which will be protected by
the PIN code .
3 - Customizing the PIN code, replace 0000 by the custmized code .
• PIN code initialisation
By default, the PIN code is not enabled . Access to settings is only
available in Standby mode .
1- By default registered PIN code is 0000 . Press
The number blinks . Save by pressing
2- For others numbers, select 0 by press
press on
again to save and exit .
The PIN code is initialized, the next setting appears: PIN code activation .
• Activation/deactivation of the PIN code
1-
appears on the display .
Press
or
to enabled PIN code .
appears on the display .
= PIN code enabled
= PIN code disabled
Cod . 1910000000276 - nv04
or
to select 0 .
.
1
2
.When 0000 appears,
2- Press
to save and return to the home installer settings display .
The PIN code is enabled . Any modification of reserved settings listed in
"Overview" is now impossible .
• Customizing the PIN code
If you have just activated the PIN code, follow the steps described below .
Alternatively, you must copy the steps 1 and 2 of the initialisation process
as well as the steps 1 and 2 of the activation process before personalising
the PIN code .
Please remember that the personalisation of the PIN code can only be set
once the initialisation and activation of the PIN code has been completed .
1- When
appears, press
2- The 0000 code appears and the first number blinks . Press
to select the first desired number then press
operation for the remaining 3 numbers .
3- Press
to confirm . The new code is now saved .
4- Press again on
to exit setting PIN code mode and go back to the
home display of the installer settings .
- 35 -
English
for at least 5 seconds .
5 sec.
to save . Repeat this
1
2
or
Publicidad
