Descargar Imprimir esta página

Cameo PIXBAR G2 SMD Manual De Usuario página 13

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 99
ENTER – Press ENTER to access the menu level to make value or status changes, and to access
one of the sub-menus. Confirm value or status changes by pressing ENTER.
NOTES:
• Before navigating the unit menu, make sure that the control panel is dry and clean
so that its functionality is not impaired.
• Water on the control unit can lead to incorrect operation of the spotlight, e.g. in
outdoor operation. Therefore, after configuring the spotlight, activate the lock
function to prevent incorrect operation by water (Settings -> Display -> Autolock).
Deactivate the lock function: Press UP and DOWN simultaneously for approx. 5
seconds.
7
PRESSURE EQUALISATION ELEMENT
Pressure equalisation element to prevent condensation inside the housing. In order to ensure its
proper function, the element must be protected from dirt.
8
W-DMX
ANTENNA
Antenna for W-DMX
control.
CAUTION: To ensure IP65 splash resistance for the DMX and network sockets, the
special input and output sockets must be correctly sealed with the IP65 special plugs
or the rubber sealing caps must be used for sealing. When connected correctly, or
when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT
sockets are protected from water sprays in accordance with IP65.
OPERATION
NOTE
• As soon as the spotlight is correctly connected to the power supply, the following are displayed
in succession: "Update wait ..." (for service purposes only), "Welcome to Cameo", the model
name and the software version. After this process, the spotlight is ready for operation and the
previously activated operating mode is launched.
• If there is no input for approx. 30 seconds, the display automatically returns to the main dis-
play.
• Note on the main display in the operating modes with external control: As soon as the control
signal is interrupted, the characters in the display start flashing; if the control signal is present
again, the flashing stops.
• Briefly pressing UP when in the main display rotates the display by 180°.
13

Publicidad

loading

Este manual también es adecuado para:

Clpbsmdipg2