Publicidad
Idiomas disponibles
Idiomas disponibles
• lf the power cable is damaged, it should be substituted with a cable
or special bundle available from the manufacturer or by contacting
the customer service department. The type of power cable must
be H05V2V2-F. This operation should be carried out by a suitably
qualified professional. The earth conductor (yellow-green) must be
approximately 10 mm longer than the other conductors. For any
repairs, refer only to the Customer Care Department and request
the use of original spare parts.
• Failure to comply with the above can compromise the safety of the
appliance and invalidate the guarantee.
• WARNING: the accessible parts can become hot when the grill is in
use. Children should be kept at a safe distance.
• Do not use rough or abrasive materials or sharp metal scrapers to
clean the oven door glasses, as they can scratch the surface and
cause the glass to shatter.
• WARNING: ensure that the appliance is switched off before replacing
the bulb, to avoid the possibility of electric shocks.
• The oven must be switched off before removing the removable
parts. After cleaning, reassemble them according the instructions.
• Only use the oven for its intended purpose, that is only for the
cooking of foods: any other use, for example as a heat source, is
considered improper and therefore dangerous. The manufacturer
cannot be held responsible for any damage resulting from improper,
incorrect or unreasonable usage.
• The use of any electrical appliance implies the observance of some
fundamental rules:
- Connection to the power source can also be made by placing
an omnipolar breaker, with contact separation compliant to the
requirements for overvoltage category III, between the appliance and
the power source that can bear the maximum connected load and
that is in line with current legislation. The yellow-green earth cable
should not be interrupted by the breaker. The socket or omnipolar
breaker used for the connection should be easily accessible when
the appliance is installed. The disconnection may be achieved by
having the plug accessible or by incorporating a switch in the fixed
wiring in accordance with the wiring rules.
- Do not pull on the power cable to disconnect the product from the
EN 7
Publicidad
