cecotec BAMBA IONICARE ROCKSTAR AIRSONIC Manual De Instrucciones página 27

3. OPERATION
1. Wash and condition your hair.
2. Dry your hair with a towel and comb it.
3. Install the concentrator nozzle on the front part of the dryer, if desired.
4. Plug the appliance into a power supply. Before plugging the appliance into the power
supply, make sure that the power switch is always in the off position.
5. Switch on the appliance by sliding the switch and select the desired air speed.
6. Select the desired mode by pressing the change of mode button repeatedly.
7. Select the desired temperature level by pressing the temperature change button
repeatedly. In baby and pet modes you can select between warm and hot air. In normal
and quick dry modes, you can also select the option of cold air.
8. The temperature indicator light ring will illuminate blue for cold air, red for hot air and both
colours for warm air (Fig. 2).
9. In either mode, press and hold the temperature button to activate the oscillating
temperature. The light ring will change between the 3 colours to indicate the change of
temperature.
10. Once you have finished using the appliance, switch it off and unplug it from the power
supply.
Warning
If you notice that the appliance switches off or stops blowing hot air, then the overheating
protection has been activated. In this case, unplug it from the power supply and allow it to
cool down for a few minutes. Before switching it back on, make sure there are no fluffs, hair, or
other objects blocking the air inlet grille.
4. CLEANING AND MAINTENANCE
- Disconnect the appliance from the power supply and allow it to cool down before cleaning.
- Use a soft, cotton cloth to clean the appliance inlets and outlets.
- Do not use sharp tools near the inlets and outlets of the appliance to avoid damage.
- Do not immerse the appliance in water or any other liquid and do not expose it to water
while cleaning it.
- Do not use abrasive scouring pads, powders, or cleaners.
- You can remove the air inlet grille to clean it with a soft cloth. To do that:
1. Make sure the hair dryer is switched off, unplugged, and has cooled down.
2. With the hair dryer in an upright position, hold the handle of the dryer and pull the grille
away from the handle.
3. Clean the grille and the interior mesh carefully.
4. Follow the reverse process to refit the grille. When the grille is placed in position, it will
magnetically adhere to the handle of the dryer.
BAMBA IONICARE ROCKSTAR AIRSONIC
ENGLISH
27