Genie Directlift 2060 Manual De Funcionamiento Y Mantenimiento página 9

2060-3060 eng.qxd 11/9/05 11:02 AM Page 9
i
/i%
........ _i]17 . ......
_£1q _E A q%.,EAHD _E}LtUSTMEKI%
tCOICI 0", , ..... _"_=*
IIougB Setti_'_g of Lissit Swit_:cBes
A Setting Close Limit Switch (Figure 9):
• Check that Carriage Assembly is disengaged.
• With garage door fully closed, slide Close Limit Switch
toward Carriage until white lever is fully lifted.
• Tighten Set Screw. Do Not over-tighten.
B Setting Open Limit Switch:
• Manually open garage door to full open position.
° Slide Open Limit Switch toward Carriage until white lever
is fully lifted.
• Tighten Set Screw. Do not over-tighten.
• Re-engage Carriage Assembly.
kis_it :s,4J c_e,s
WARNING
• The garage door opens rapidly, and can cause serious
injury or death.
• Keepthe path clear.
• Position the ladder to the side of the Power Head so it is
clear of all moving parts of the Opener and the door.
• Set the door Opener to use the minimum force needed
to open the door.
A
CLOSE ADJUSTMENT
• On front panel of Power Head find adjusting screw
marked "CLOSE" (Figure 9).
• Gently turn screw counterclockwise until it stops.
- Very little force is required to turn adjusting screw.
• Press Wall Console to close garage door.
- Observe if door stops at"CLOSE" limit switch.
If door is fully closed--adjustment is finished.
Go to "OPEN" Adjustment.
- If door stops but is not fully closed,
a. Measure distance between bottom of door
and floor.
b. Move "CLOSE" Limit Switch that same distance
toward door.
- If door stops and/or reverses before reaching the
"CLOSE" Limit Switch
a. Slightly increase CLOSE Force setting (clockwise).
- If door reverses after contacting floor, move Limit
Switch toward Power Head.
- If door fails to move, check Safe-T-Beam ® System. See
Troubleshooting Section, page 14.
• Tighten Limit Switch Set Screw. Do not over-tighten
(strip) Limit Switch Set Screw.
NOTE
o
Little effort is required to turn the Force
Adjusting Knobs.
• If the door stops moving while opening or
closing, adjust the Open Force or Close Force
Controls slightly clockwise (to slightly
increase the force) and retry the step.
• The Open Force and Close Force Controls are to
be set to the minimum force necessary to
ensure the door smoothly opens and
closes completely.
• Ensure the Carriage Assembly is engaged and is
between the two Limit Switches before
operating the Opener.
FORCE
CONTROLS
Figure 9 Making Force Adjustments
,/i'%
........ \117...
Open adjustment next page.
9
i
......................... L_I N ........................