Goodwe SMT Serie Guía De Instalación Rápida página 4

EN
Product:
1. Do not apply mechanical load to the terminals, otherwise the terminals can be damaged.
2. All labels and warning marks should be visible after the installation. Do not scrawl, damage,
or cover any label on the device.
3. Unauthorized dismantling or modification may damage the equipment, the damage is not
covered under the warranty.
4. Install the inverter away from high magnetic field to avoid electromagnetic interference.If
there is any radio or wireless communication equipment below 30MHz near the inverter, you
have to:
• Install the inverter at least 30m away from the wireless equipment.
• Add a low pass EMI filter or a multi-winding ferrite core to the PV-DC input cable or AC
output cable of the inverter.
5. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD
Disconnect all incoming
power and turn off the
product before working on it.
Read through the user
manual before any
operations.
High-temperature hazard. Do
not touch the product under
operation to avoid being
burnt.
CSA marking for the United
States of America and Canada
300612
Check before Power-on
No.
The product is firmly installed at a clean place that is well-ventilated and easy-to-
1
operate.
The PE, DC input, AC output, and communication cables are connected correctly and
2
securely.
3 Cable ties are intact, routed properly and evenly.
4 Unused ports and terminals are sealed.
The voltage and frequency at the connection point meet the inverter grid connection
5
requirements.
Delayed discharge. Wait 5
minutes after power off until
the components are completely
discharged.
Potential risks exist. Wear
proper PPE before any
operations.
Grounding point.
Do not dispose of the inverter
as household waste. Discard
the product in compliance with
local laws and regulations,
or send it back to the
manufacturer.
Check Item
2