Ultrasport Mini Bike 50 Manual Del Usuario página 21

COMPUTER FUNCTION
Adjusting the training computer
The training computer displays various
training data.
Press the select button (1A) The training
computer switches on.
Press the select button (1A) repeatedly until
the desired function is selected. You can
switch between the following functions:
STOP
SCAN
T = Time
D = Distance
C = Pedal revolution count
T-C =
Total pedal revolution count
CA = Calories
The training computer automatically stops the measurement if
the pedals have not been pressed for more than four seconds.
If you stop the exercise for more than four seconds the STOP
function will be selected automatically. The training computer
will stop measuring the training data until you continue the
exercise.
If you select this function the display will switch between the
functions T, D, C, T-C and CA automatically every six seconds.
This function shows you how long you have been doing an
exercise.
This function shows you the distance you have traveled during
an exercise.
This function shows you how many pedal revolutions you
have completed during an exercise.
The monitor will accumulate total numbers of di erent
training period. This data can be reset to zero by replacing
battery.
This function shows you approximately how many calories
you have burnt during an exercise.
The training computer switches o automatically after about
four minutes if:
-
The pedal arms have not been turned within the four
minutes end.
-
You have not pressed the select button during that time.
The training computer then resets all training data except
for T-C to zero.