Publicidad
Idiomas disponibles
Idiomas disponibles
2
POP-UP DRAIN
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
3
REMOVE FLANGE
• Thread FLANGE (1) counter-clockwise and
remove FLANGE (1) and FOAM GASKET (2)
from drain body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.
4
INSTALL DRAIN FROM
BELOW FIXTURE
• From under side of SINK
install DRAIN BODY (1) up
through drain outlet.
Note: No plumber's putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the SINK.
• Install FOAM GASKET (3) on
to bottom of flange and
assemble FLANGE (4) onto
drain body from above sink
and tighten FLANGE (4) firmly.
6
FLANGE GASKET AND POP-UP KNOB
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• POP-UP KNOB (1) must be pressed completely
down Fig.B while pop up is in the full up position.
Fig. A.
2
Fig. A.
1
4
DRAIN
OUTLET
3
Fig. A.
WHITE FOAM
GASKET
NOT VISIBLE
- 2 -
1
3
2
5
TIGHTEN LOCKNUT
• Tighten LOCKNUT (1) firmly with Adjustable
REAR
Wrench or Channel Locks.
OF
SINK
1
2
1
DRAIN
FLANGE
Fig. B.
DRAIN
BODY
4
Fig. B.
4
3
1
Fig. B.
DOWN
up
M965624 Rev. 1.4 (3/22)
2
Publicidad
