Publicidad
Idiomas disponibles
Idiomas disponibles
7
ATTACH CABLE CONNECTOR
• Thread CABLE CONNECTOR (1) clockwise
onto DRAIN BODY CONNECTION (2) and
hand tighten. Fig. A.
Your new POP-UP DRAIN installation is
now complete. Fig. B.
Note: Tailpipe on pop-up drain is 1-1/4" O.D.
Fig. B.
8
CHECK OPERATION OF POP-UP
• Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
closes.
Note: If STOPPER (2) does not open and close properly then
refer to the "troubleshooting section" of these instructions.
9
MAKE WATER SUPPLY AND WASTE CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST
BE PURCHASED SEPARATELY.
• Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
• Use adjustable wrench to tighten connections. Do not over
tighten. Be careful not to kink copper supply when bending.
Use tubing cutter to cut to proper length.
• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to
waste outlet
Fig. A.
2
1/2" PIPE
THREAD
2
FLEXIBLE
SUPPLIES
3/8" COMPRESSION
CONNECTION
- 3 -
Fig. B.
1
2
M965624 Rev. 1.4 (3/22)
1-1/4" O.D.
1
1
COUPLING
NUT
3
3/8 O.D.
BULL-NOSE
RISERS
COMPRESSION
NUT
FERRULE
COLD
Publicidad
