Husqvarna 330iKE Manual Del Usuario página 11

CAUTION:
left-hand thread. To tighten the
locknut to much can cause damage
to the threads.
The locknut secures the cutting attachment on
the output shaft. Protect your hand from injury
when assembling, use the cutting attachment
guard as protection when tightening with a
socket wrench.
1. When fitting, tighten the locknut in the
opposite direction to the direction of
rotation of the cutting attachment. To
remove it, undo the locknut in the same
direction as the cutting attachment rotates.
2. Put a small screwdriver or locking pin (A)
in the hole on the drive disc to lock the
blade.
3. Tighten the locknut to a torque of 11-15
ft-lb / 15-20 Nm.
To do a check of the keypad
• Push and hold the power button (A).
B
a) The product is on when the LED (B) is
on.
2114 - 004 - 03.11.2023
The locknut has a
A
A
b) The product is off when the LED (B) is
off.
To do a check of the power trigger lockout
The power trigger lockout prevents accidental
start. When you push the power trigger
lockout (A) forward, it releases the power
trigger (B). When you release the handle, the
power trigger and the power trigger lockout
move back to their initial positions.
A
1. Make sure that the power trigger is locked
when the power trigger lockout is in its
initial position.
2. Push the power trigger lockout (A) forward.
Make sure that it moves back to its initial
position when you release it.
B
A
11