Defiant 17000215 Guía De Uso Y Cuidado página 6

Installation
1
Determining the mounting
location
NOTE:
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
NOTE:
close enough together for the cord to reach.
Determine the mounting location – wall or eave
mount.
Position the lamp heads (A) in the general
direction of the desired light coverage.
If needed, rotate the motion sensor (C) so the
controls face the ground after installation.
2
Installing the mounting plate
NOTE: Make sure there is enough vertical space above
Place the mounting plate (D) against the
mounting surface and ensure the mounting
plate (D) is level. Mark the hole locations.
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the mounting plate (D) and into
the mounting surface.
3
Mounting the light fixture
the mounting plate (D) until it snaps into place.
Wall Mount
A
THIS SIDE UP
C
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
mounting plate (D) using the two mounting
screws (AA).
AA
6
THIS SIDE UP
Eave Mount
D
B
D