Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
6
Preparing the light fixture for
initial charge before installation
NOTE: The solar xture initial charge has two options to
charge the light xture to full battery capacity during set up.
To reduce intial solar charge time method 6A can be used
and the light xture installed outdoors. Method 6B can be
chosen to charge the light xture while the light xture is set
up outdoors immediately.
6A
Connecting the USB cable to the light xture for
initial charge
A USB cable has been included for rapid
charge of the solar xture before installation.
Take the USB cable and plug the end (A) into
the light xture charging port (B).
Place a power block (not included) onto the
USB cord half (C) and plug this into the
standard wall socket.
Allow to charge for at least 10 hours
After 10 hours, remove the USB cable from the
xture and plug the light xture into the solar
panel cord. Light xture is now ready for
installation and use.
USB cable is not for outdoor use
6B
Connecting the solar panel to the light xture
for initial charge
Carefully route the solar panel cable (1) to
Leave enough loose cable to form a drip
Set Solar Fixture to OFF position until xture has
been fully charged in a 2 to 5 day period depending
on amount of sun per day
NOTE: Wrap any excess solar panel cable around the arm
located behind the solar panel. Leave enough loose cable
to form a drip loop (3).
C
B
8
B
A
2
1
3
1
Publicidad
