Defiant 17000215 Guía De Uso Y Cuidado página 9

Operation
1
Adjusting the lamp heads
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Rotating the sensor controls
downward
CAUTION: To avoid water damage, the motion sensor
controls must be facing the ground when installation is
complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
3
Determining the motion sensor
detection zone
NOTE: When the motion sensor control switch is set to
the "TEST" position, the light will operate during the day or
night. The light will stay on for approxiatemently 5 seconds
after all motion is stopped.
NOTE: The motion sensor will need to completely warm
up approximately (50 seconds) before beginning the setup
process.
Slide the control switch to the "TEST" position.
Slide the "SENS" switch to the "L" (low)
position.
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
Watch the light (B). The light (B) will come on
indicating low battery.
Stop, wait for the light (B) to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
A
C
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
B
C
9
Please contact 1-866-308-3976 for further assistance.
THIS SIDE UP
THIS SIDE UP
THIS SIDE UP
HOMEDEPOT.COM