Publicidad
Idiomas disponibles
Idiomas disponibles
Attach clamp bracket to table edge
with 2 each
cap screw M 6x20
washer Ø 6.4
serrated lock washer Ø 6.4
hexagon nut M 6
1 pc starknob screw M 6x20
Fit slide washer into the groove of
the link bracket extrusion.
Slide one stop plate and two car-
riage bolts M 6x20 into groove of
fence extrusion.
Put a carriage bolt M 6x20 through each of the two holes on the left table
edge and screw nuts on loosely. Slide link brackage extrusion onto heads
of the carriage bolts.
- Do not yet tighten bolts -
Place ratchet lever M 8x20 through
slot of link bracket angle bar and
screw into slide washer.
Install the prepared fence extrusion
to the link bracket angle bar with
two starknobs M 6.
10
Place pivot bolt through hole into
clamp bracket and lock with star-
knob screw M6x20.
Slide second stop plate into fence
extrusion groove.
Publicidad
