Publicidad
Idiomas disponibles
Idiomas disponibles
Install 4 double collar bolts to the
left side panel of the saw.
Use 4 each
double collar bolt
hex. nut M 8
serrated lock washer Ø 8.4
1. Remove backstop plate
2. Slide traversing bracket on ex-
trusion
3. Reinstall backstop plate
The sliding carriage table should be set approx. 1 - 2 mm higher than the saw table. Set level with the saw's table
by turning the setting screws in or out. Verify setting by placing fence extrusion over both tables. To align carriage
parallel with the saw blade, adjust setting screws. Check setting with a vernier calliper.
Hook roller carriage extrusion to
double collar bolts.
Place sliding carriage table onto
traversing bracket and align with
saw table, then bolt to saddle.
Use 4 each
hex. head screw M 8x16
washer Ø 8.4
hex. nut M 8
9
Secure machine with clamp on
workstand.
Loosen counter nuts of the extru-
sion brackets (1 turn). By turning
the cam plate (402) with a 24 mm
spanner the sliding carriage table's
height can be adjusted against the
saw table.
Publicidad
