STEINEL DALI64 KNX-S Manual De Instrucciones página 18

DALI Gateway DALI64 KNX-S, DALI Gateway DALI128 KNX-S
– Control of max. 2x 64 DALI devices in max. 2x 32 groups ("2-fold" device vari-
ant)
– Setting the colour temperature or light colour (RGB, RGBW) for luminaires
with DALI Device Type 8 in accordance with IEC 62386-209
– Short-circuit, overload and overvoltage protected
– Operating hours counter
– Automatic colour wheel sequence or brightness sequence
– HCL mode (Human Centric Lighting), automatic daytime colour temperature
profile
– CT (Colour Transition) mode, automatic daytime colour profile
– Suitable for operation of emergency lighting systems with DC voltage
– Individual, group or central addressing
– 16 light scenes per DALI system
– Reading out of DALI device states via KNX, e.g. brightness or luminaire error
– Manual operation of the DALI groups, single devices or central (broadcast)
separately for each DALI system
– Restraint or disabling functions
– Feedback of switching state and brightness value in bus and manual mode
– Collective feedback
– Central switching and dimming function
– Disabling function for each DALI group or each single device
– Separate switch-on and switch-off delay
– Staircase lighting timer with run-on time
– Online or offline project design of the DALI devices with ETS-DCA
– Standby switch-off of the DALI devices
– An individual DALI device of the same type can be exchanged during opera-
tion without software
Delivery state: Construction site mode, manual operation is enabled. The connected
DALI operating devices of both DALI systems can be controlled via the keypad via
the broadcast function.
The complete functionality of the DALI system can only be ensured if DALI-2
operating device is used exclusively.
A complete list of DALI-2 operating and control devices can be found here: ht-
tps://www.dali-alliance.org/products
82406608 4 / 14 23.01.2024