STEINEL DALI64 KNX-S Manual De Instrucciones página 21

DALI Gateway DALI64 KNX-S, DALI Gateway DALI128 KNX-S
Operating DALI devices
The device is in permanent or temporary manual operation mode.
Press Ǖ (1) button briefly as many times as necessary until the desired DALI num-
ber is indicated (8).
￭ Operate output with ON|+ (3) button or OFF|− (5) button.
Short: switch on/off.
Long: dim brighter/darker.
Release: Stop dimming.
The LEDs ON|+ (4) and OFF|− (6) indicate the status.
The display (8) shows first the numbers of the available DALI groups (8a), followed
by the individual addresses of the DALI devices (8b).
Switch off all DALI devices
The device is in permanent manual operation mode.
￭ Press the ALL OFF button (7).
Disabling/enabling individual DALI devices or groups
The device is in permanent manual operation mode and the lock is released.
Press Ǖ (1) button briefly as many times as necessary until the desired DALI num-
ber is indicated (8).
￭ Press the buttons ON|+ (3) and OFF|− (5) simultaneously for at least 5
seconds.
The selected DALI number flashes on the display (8).
DALI device or group is blocked.
- or in case of repeated actuation -
The display (8) no longer flashes.
DALI device or group is enabled.
￭ Activate bus mode (see section Switching the permanent manual mode on/
off).
DALI devices blocked via manual operation can be operated in manual mode.
82406608 7 / 14 23.01.2024