STEINEL DALI64 KNX-S Manual De Instrucciones página 28

DALI Gateway DALI64 KNX-S, DALI Gateway DALI128 KNX-S
Deactivate permanent manual operation mode.
Cause 3: Application programme has been stopped; programming LED is flashing.
Perform reset: Disconnect device from bus, switch on again after approx. 5
seconds.
Cause 4: Application programme is not loaded.
Check and correct the programming.
5.3 Warranty
We reserve the right to make technical and formal changes to the product in the in-
terest of technical progress.
We provide a warranty as provided for by law.
STEINEL GmbH
Dieselstraße 80-84
33442 Herzebrock-Clarholz
Telefon +49 5245 448 0
www.steinel.de
product@steinel.de
82406608 14 / 14 23.01.2024