STEINEL DALI64 KNX-S Manual De Instrucciones página 27

DALI Gateway DALI64 KNX-S, DALI Gateway DALI128 KNX-S
Installation width
Connection mode
Connection torque, screw terminals
5.2 Troubleshooting
Indication shows "Er", connected DALI devices have no function, no operation
possible
Cause: Mains voltage on DALI cable.
Installation error. Disconnect device and connected DALI devices from mains
voltage and disconnect bus voltage. Correct installation.
Indication shows "bc" in manual mode, control of individual luminaires not possible.
Cause: The device is not programmed or is programmed for central control.
Check device status or change operation from broadcast to group or individual
control.
Individual DALI devices have no function
Cause 1: Load is defective, e.g. lamp.
Exchange load.
Cause 2: DALI device is defective.
Exchange defective device.
Switch on voltage.
Press Ǖ and ALL OFF buttons together for at least 10 seconds.
The device detects the exchanges DALI device and loads in the necessary
data. The display (8) shows LE.
Simultaneous exchange of multiple DALI devices is only possible with commissioning
software (DCA) and project data.
DALI groups or single devices cannot be operated
Cause 1: DALI groups or single devices disabled via bus or manual operation.
Cancel disabling.
Cause 2: Permanent manual mode is switched on.
82406608
Figure 5: Clampable cable cross-sections
13 / 14
72 mm / 4 HP
Screw terminal
max. 0.8 Nm
23.01.2024