STEINEL DALI64 KNX-S Manual De Instrucciones página 25

DALI Gateway DALI64 KNX-S, DALI Gateway DALI128 KNX-S
￭ Perform the ETS programming operation,
or
￭ Cause bus voltage failure.
Master reset
The master reset restores the basic device settings (physical address 15.15.255,
firmware remains in place). The device must then be recommissioned with the ETS.
Manual operation is possible.
In secure operation: A master reset deactivates device security. The device can then
be recommissioned with the device certificate.
Performing a master reset
Precondition: The safe-state mode is activated.
￭ Press and hold down the programming button for > 5 s.
The programming LED flashes quickly.
The device performs a master reset, restarts and is ready for operation again
after approx. 5 s.
Restoring the device to factory settings
The device can be reset to factory settings with the STEINEL KNX Service App . This
function uses the firmware contained in the device that was active at the time of de-
livery (delivered state). Restoring the factory settings causes the device to lose its
physical address and configuration.
82406608 11 / 14 23.01.2024