Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
PROPER INSTALLATION
This washer must be properly installed and located in accordance with the Installation Instructions before it is used.
Ensure that the hot water hose is connected to the "H" valve and the cold water hose is connected to the "C" valve.
Install or store where it will not be exposed to temperatures below freezing or exposed to the weather, which
could cause permanent damage and invalidate the warranty.
Properly ground washer to conform with all governing codes and ordinances. Follow details in the Installation Instructions.
WARNING
Plug into a grounded 3 prong outlet.
DO NOT remove ground prong.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to follow these instructions can result in death, fire or electrical shock.
Ensure washer is properly leveled and washer legs are adjusted such that unit is stable.
Optional drain hose extension recommended for discharging heights from 60" - 96".
GE Appliances strongly recommends the use of factory specified parts. A list of factory hoses available for
purchase are listed. These hoses are manufactured and tested to meet GE Appliances specifications.
GE Appliances strongly recommends the use of new water supply hoses. Hoses degrade over time and need
to be replaced every 5 years to reduce the risk of hose failures and water damage.
Consider recycling options for your appliance packaging material.
START-UP SEQUENCE
When the washer cycle is first started, there will be a pattern of blinking lights running from right to left through
the Centrifugar (Spin), Enjuagar (Rinse), Lavar (Wash), Remojar (Soak) and Llenar (Fill) lights. All LED's will turn
off for over 10 seconds before the Llenar (Fill) light turns on.
Any time the washer is being started or restarts after the washer lid has been opened and closed, the washer will turn
on the cold water valve for two short periods followed by a 10 second pause before continuing. If the lid is opened during
this period, the washer will pause. You will have to push the INICIO (Start) button again to restart the cycle.
The Ciclo Completo (Complete) light will turn on when the washer has finished running a cycle. If the washer
is off and the Ciclo Completo (Complete) light is not on, the cycle completed more than an hour ago or the
washer cycle ended prematurely due to a fault.
AUTOMATIC DRAIN SEQUENCE
Machine will automatically drain anytime the lid is left open for more than 15 minutes and water is present.
The Llenar (Fill) light will blink three times repeatedly when the draining begins.
Machine will automatically drain if left in a paused state with lid closed for more than 24 hours and water is present.
WHEN NOT IN USE
Turn off water faucets to minimize leakage if a break or rupture should occur. Check the condition of the fill
hoses; GE Appliances recommends changing the hoses every 5 years.
PARTS AND ACCESSORIES
Order on-line at GEApplianceparts.com today,
24 hours a day or by phone at 800.626.2002 during
normal business hours.
READ AND SAVE THESE INSTRUCTIONS
4
- Electrical Shock Hazard
Part Number
Accessory
WH49X301
Drain Hose Extension
PM14X10002
4 ft - Rubber Water Supply Hoses
Or
PM14X10005
4 ft - Braided Water Supply Hoses
PM7X1
Washer Floor Tray
49-3000387 Rev 0
Publicidad
