GENERGY CUBE Serie Instrucciones De Uso página 86

3 Using a screwdriver, loosen the carburetor draining screw. Gasoline will begin
streaming from the carburetor draining hole. Once all of the gasoline is drained,
tighten the draining screw again.
4 Remove the spark plug (see pint 10.3 of this manual) and pour a tbsp of clean
motor oil (10 ~ 20 ml) in the cylinder. Pull the startup handle gently, this will
make the engine spin and distribute the oil. Then install the spark plug again.
5 Pull the starter rope slowly until you feel resistance. In this point, the piston is
rising in its compression stroke and the intake and exhaust valves are closed.
This position helps protecting the engine against internal corrosion.
OIL DRAINING
DRAINING SCREW
STARTUP HANDLE
83