Connecting Power Cord; Machine Operation; Pre--Operation Checks - Tennant WB-20E Manual Del Operador

OPERATION
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.

CONNECTING POWER CORD

1. Connect 23M (75 ft) extension cord to machine's
pigtail cord.
2. Plug extension cord into a grounded wall outlet
(Figure 9)
Grounded
3 Hole Outlet
Ground Pin
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug power
Cord Before Servicing Machine.
FOR SAFETY: Do not operate machine with the
use of additional extension cords. Only use
manufacturer's extension cord equipped with
machine which has proper capacity and is
grounded.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE- -OPERATION CHECKS
1. Sweep and dust mop floor.
2. Inspect power cord for damage, replace
immediately if damaged.
3. Check that a pad/brush is installed.
4. Check that squeegee is installed.
10
FIG. 9
1. Adjust control grips to a comfortable operating
height (three settings). Squeeze together the two
levers under the console to raise or lower control
grips (Figure 10).
FIG. 10
2. Lower squeegee by releasing squeegee lift lever
from the lock position (Figure 11).
FIG. 11
3. Lower brush head, step down firmly on top brush
lift pedal and push pedal forward to lower
(Figure 12).
FIG. 12
4. Turn vacuum switch to the on position.
WB- -20E (07- -10)