Connecting Power Cord; Machine Operation; Pre--Operation Checks - Tennant 5200 Manual De Operador

OPERATION
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.

CONNECTING POWER CORD

Connect the supplied extension cord to machine. Plug
cord into a grounded wall outlet (Figure 9).
Grounded
3 Hole Outlet
Ground Pin
FIG. 9
FOR SAFETY: Do not operate machine with the
use of additional extension cords. Only use
manufacturer's extension cord equipped with
machine which has proper capacity and is
grounded.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug power
Cord Before Servicing Machine.
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
PRE- -OPERATION CHECKS
1. Sweep and dust mop floor.
2. Inspect power cord for damage, replace
immediately if damaged.
3. Check that a pad/brush is installed.
4. Check that squeegee is installed.
8
Home Find... Go To..
1. Adjust control grips to a comfortable operating
height (three settings). Squeeze together two
levers under console to raise or lower control grips
(Figure 10).
FIG. 10
2. Lower squeegee by releasing squeegee lift lever
from the lock position (Figure 11).
FIG. 11
3. Lower brush head, step down firmly on top brush
lift pedal and push pedal forward to lower
(Figure 12).
FIG. 12
4. Turn vacuum switch to the on position.
Tennant 5200 Electric (06- -04)