MESTO FERROX PLUS 3585P Instrucciones De Uso página 16

EN
Preparation
Observe the instructions in the section entitled „Safety".
The device must be in an upright position.
If filling the tank from a water line, ensure that the line or a hose does not project
into the tank.
1. Pull up the red button on the safety valve [12] until all excess pressure is released from
the tank. (Fig. 4).
2. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 5).
3. Unscrew the pump [2] from the tank [1]. (Fig. 6).
+
To ensure the pump remains clean during storage, we recommend you attach the
pump to the pump holder [8]. (Fig. 7).
+
We recommend you mix the spraying liquid in the device or premix it in an external tank:
Fill to 1/3 with water, pour in the spraying agent, and then add more water until full.
4. Add the spraying liquid to the tank [1] (Fig. 7).
5. Screw the pump [2] into the tank [1]. (Fig. 9).
6. Swivel in the pump holder [8]. (Fig. 9).
Without compressed-air filling valve
7. Press the pump handle [13] down and turn it clockwise.
► The pump handle is unlocked. (Fig. 10).
8. Generate the required pressure (→ Table 2) in the tank [1] (Fig. 11).
+
The maximum pressure should not exceed 6 bar (red line on the pressure gauge
[16], Fig. 11). If the maximum pressure is exceeded, the safety valve will engage and
release the excess pressure
9. Press the pump handle [13] down and turn it counterclockwise.
► The pump handle is locked in place. (Fig. 5).
With compressed-air filling valve (option)
7. Connect the compressed-air hose [17] to the compressed-air filling valve [18]. (Fig. 12).
► Pressure is built up max. 6 bar (88 psi)
Ensure that the initial pressure is not higher than 15 bar (218 psi).
8. When the required pressure has built up (→ Table 2), remove the compressed-air
hose [17].
16
ENGLISH