Saf-Fro DIGISTEEL 385C PRO Manual De Instrucciones página 22

To save data into USB device:

Connect the USB to welding machine.

Add USB icon to the Welding parameters bar [44].

Use the Right Knob [36] to highlight the icon "USB".
Figure 21.

Press the Right Knob [36] to confirm the selection –
the USB menu is shown on the display.

Use the Right Knob [36] to highlight the icon "Save".
Figure 22.

Press the Right Knob [36] to get access of Save
option – the save menu is shown on the display.
Figure 23.
English

Create or choose a file in which will be saved copies
of the data.

The display shows the Save Data Menu on a USB
Memory Stick.

Use the Set Control [11] to highlight the data icon
which will be saved in the file on a USB Memory
Stick. For example: Configuration Menu icon.

Press the Right Knob [36] to confirm.

To confirm and save the data on a USB Memory
Stick, highlight the Check Mark icon and then press
the Right Knob [36].

To exit the USB Menu – press the Left Button [37] or
disconnect the USB Memory Stick from the USB
receptacle.
18
Figure 24.
Figure 25.
Figure 26.
English