Beurer BM 45 Manual De Instrucciones página 32

If the symbol is displayed and does not disappear,
measurement is no longer possible. Replace all the batteries.
Once the batteries have been removed from the device, the
date and time must be set again. Any saved measured values
are retained.
Operation with the mains part
You can alternatively also operate this device with a mains
part (not included in delivery). However, before connecting
the device with the mains part, please ensure that you have
removed the batteries from the device. During mains opera-
tion, there must not be any batteries in the battery compart-
ment, as this could damage the device.
• To avoid any potential damage, the device may only be
operated with a mains part that meets the specifications
described in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to
the mains voltage that is specified on the type plate.
• First, remove the protective cap of the mains part con-
nector – located on the rear of the device – and insert the
mains part into the connection intended for this purpose.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the date
and time setting but the saved measured values are re-
tained.
Adjusting the settings
Make sure that the device's settings have been set correctly
so you can make full use of all its functions. Otherwise you
will not be able to save your measured values with the date
and time and access them later.
There are two different ways to access the settings menu:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be tak-
en to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off, press and hold the START/
STOP button for approx. 5 seconds.
Set these settings in the order shown below:
Hour format
➔
Press to confirm your selection each time.
32
Date Time
➔