Beurer BM 45 Manual De Instrucciones página 35

If you forget to turn off the device, it will switch off au-
tomatically after approx. 3 minutes. In this case too, the
value is stored in the selected or most recently used user
memory.
6.3 Taking a blood pressure measurement
Requirement: cuff attached, user selected.
Measurement
1. Press . All display elements are briefly displayed. The
cuff inflates itself automatically. The measurement process
starts. is displayed as soon as a pulse is detected.
To cancel the measurement, press
2. The systolic pressure, diastolic pressure and pulse meas-
urements are displayed.
is displayed if the measurement could not be per-
formed properly. In this case, please refer to the "Trou-
bleshooting" section.
If necessary, re-attach the cuff after 1 minute.
The device switches off automatically after approx.
3 minutes. The value is saved to the selected or most
recently used user.
6.4 Evaluating the results
General information about blood pressure
• Blood pressure is always stated in the form of two val-
• The highest pressure is the systolic blood pressure.
• The lowest pressure is the diastolic blood pressure.
• Fluctuations in blood pressure are normal. Even during
.
Cardiac arrhythmia
The device can identify heart rhythm abnormalities during
the blood pressure measurement. If
the measurement, this indicates that an irregularity has been
detected in your pulse.
Repeat the measurement if
35
ues:
This occurs when the heart muscle contracts and blood
is pumped into the blood vessels.
This occurs when the heart muscle has completely re-
laxed again and the heart is filling with blood.
repeat measurements, there may be considerable differ-
ences between the measured values. One-off or irregular
measurements therefore do not provide reliable informa-
tion about the actual blood pressure. Reliable assess-
ment is only possible when you perform the measure-
ment regularly under comparable conditions.
is displayed after
is displayed.