GreenWorks Pro CS80L00 Manual Del Propietário página 38

TROUBLESHOOTING
PROBLEM
Bar and chain
running hot and
smoking.
Motor runs, but
chain is not rotating.
Motor runs, chain
rotates but does not
cut.
Chainsaw does not
start.
POSSIBLE CAUSE
Check chain tension for
overtightened condition.
Chain oil tank empty.
Chain tension too tight.
Check guide bar and chain
assembly.
Check guide bar and chain
for damage.
Chain Brake Is Engaged
Dull chain.
Chain on backwards.
Battery is not charged.
Switch is defective.
SOLUTION
Tension chain. Refer to Page 31.
Add bar and chain oil.
Refer to Chain Tension Guide earlier in this
manual.
Refer to Page 29.
Remove the battery from the unit. Take the bar
cover off, and remove the bar and chain. Clean
all debris from the chainsaw. After all debris is
cleared, insert battery and run the chainsaw.
If the sprocket is spinning your motor is okay.
If the sprocket is not spinning, call customer
service at 1-855-345-3934.
Dis-engage chain brake, pull
towards front handle.
Sharpen chain.
Reverse direction of chain.
Place battery into the charger and allow
charging up to 30 Minutes (2Ah) or 1 Hour
(4Ah).
Call our customer service number at
1-855-345-3934 for a service dealer or
replacement parts.
38