GreenWorks GD60PHT51 Manual Del Operario página 4

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is intended for cutting and trimming hedges and
bushes in domestic use.
1.2 OVERVIEW
Figure 1
1 Blade
2 Pivoting head
3 Pivoting button
4 Coupler
5 Safety lock button
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.1 FIT THE PIVOTING HEAD
Figure 2
6 Trigger
7 Rear handle
8 Battery release button
9 Auxiliary Handle
WARNING
WARNING
WARNING
English
1. Align the handle with the trimmer head.
2. Push the trimmer head onto the handle.
3. Fasten the coupler.
Periodically check the connections to ensure that they are
tightened securely.
3.2 REMOVE THE PIVOTING HEAD
Figure 3
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the poviting head.
3.3 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Loosen the screws in the handle with a screwdriver (not
included) and remove the screws from the handle.
2. Attach the auxiliary handle and clamp on the shaft.
3. If necessary, adjust handle up or down to desired
operating position.
4. Insert and tighten the screws so that the handle cannot be
rotated on the shaft.
3.4 INSTALL THE BATTERY PACK
Figure 5
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
• Do not put your fingers into the notches or in position
where they can get cut.
4
WARNING
WARNING