Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
7
TROUBLESHOOTING
Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
Too much noise
and/or vibration is
experienced while
working.
8
TECHNICAL DATA
Voltage
No load speed
Possible cause
Solution
Make sure that
The battery pack is
you tighlty instal-
not installed tight-
led the battery
ly.
pack in the ma-
chine.
The battery pack is
Charge the battery
out of power.
pack.
The machine has
Do not use the ma-
damage.
chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are
then clear block-
blocked.
age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
60V
3200 (±10%)
-1
min
English
Blade speed
Blade length
Cutting capacity
Weight (without battery pack)
Measuered sound pressure level
Guaranteed sound power level
Vibration
Uncertainty
Battery model
Charger model
9
WARRANTY
(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10
EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
GLOBGRO AB
Globe Group Europe
Address:
Riggaregatan 53 211 13 Malmö Sweden
Name and address of the person authorised to compile the
technical file:
Name:
Peter Söderström
Address:
Riggaregatan 53 211 13 Malmö Sweden
Herewith we declare that the product
6
3200 (±10%)
-1
min
510 mm
30 mm
4.2 kg
80 dB(A),
K
=3 dB(A)
PA
94 dB(A)
2
≤2.5 m/s
2
1.5 m/s
G60B2,G60B3
,G60B4,G60B
6 and other
BAC series
G60C, G60UC,
G60UC4 and
other CAC ser-
ies
Publicidad
