Skymsen PS-22 Manual De Instrucciones página 4

Make sure that the voltage of the power source where
the equipment will be installed is compatible with the
voltage indicated on the label on the power cord.
3.3 Pre Operation
Before using your equipment, should you wash all parts that
come into contact with the product to be processed, with
water and neutral SOAP (see item 3.4 cleaning).
Verify that the equipment this firm in your workplace.
When mounting the full mouth, do not over tighten the
wheel no. 03 (fig. 01), thus avoiding locking or breaking of
the internal components.
4. Operation
4.1 Functioning
Turn off the equipment at any time to remove your
mouth. The equipment is silent. Don't let utensils such as
knives, hooks and others, about the security Tray.
Make sure that the constituent Assembly of the mouth, is in
the correct sequence, as shown in (fig. 03)
The firing is done as described below:
1 put the plug of the equipment in electric power socket.
2-check that the safety Tray N° 04 (fig. 01) is properly
positioned in its place of work;
3-Press the on/off switch N° 06 (fig. 01) to the position "I"
making that call equipment.
4.2 Procedure for Operation
Under no circumstances use strange instruments
(cutlery, cables, etc.) to push the product to be rendered
to the inside of the mouth, much less your hands. Use the
socket N° 01 (fig. 01) to do this operation. The product to be
rendered inside the mouth, it has the function to lubricate
and cool the components of same. Therefore, do not leave
connected equipment on empty, because in this way, warm
too, and will damage your components.
The meat mincer is an equipment that works at high speed
and to do so requires that the power supply is also fast.
To feed him, put the meat on the tray N° 04 Security (fig. 01),
and drive the same with hands until the entry of the power
nozzle. With the help of the socket number 01 (fig. 01) push
them to the inside of the mouth, where they will be pulled
by the worm screw.
4
4.3 Mounting of internal components of the mouth
Note the position of the internal components of
the mouth for no inversions of the same, because if this
happens, irreparable harm will occur.
PICTURE 03
06
07
01 - Mouth
02 - fiber Washer
03 - worm Screw
04 - worm screw Pin
5. CLEANING
Pull the plug out of the socket before starting the
cleaning process.
The equipment must be totally clean and sanitized:
-Before being used for the first time;
-After the operation of each day;
-Whenever it is not used for a prolonged period;
-Before putting it into operation after a prolonged downtime.
Some part of the equipment can be removed for cleaning
as:
-Pan, socket, and Its internal components
-Remove the socket N° 01 (fig. 01) security tray N° 04 (fig.
01), to facilitate the withdrawal of the mouth.
-To remove the Mouth, proceed as below:
-Remove the wheel N° 03 (fig. 01) and then its internal
components, in order to do so, pull them out.
01
02
03
04
05
05 - Blade
06 - 5 mm Disk, (optional 3
mm and 8 mm)
07 - Wheel