Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Empty the dust case and clean the adhered dust
off the mesh filter.
Fig.18
3.
Place the dust case back onto the cyclone body to
secure it in place with clicks.
1
Fig.19
► 1 . Dust case 2. Release buttons 3. Cyclone body
CAUTION:
The dust may fly up when dis-
posed out of the dust case. Be careful not to let
the dust get into your eyes.
NOTICE:
When the dust case becomes dirty,
remove and wash it with water. Dry the dust case
thoroughly before reassembly and use.
NOTICE:
Make sure all the attachments and com-
ponents are secured in place properly before use.
NOTICE:
If the suction force does not recover
even after disposing of the dust and cleaning the
mesh filter, check whether dust has accumulated
inside the cyclone body or clogging has occurred.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched
off and the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
3
2
11 ENGLISH
After use
CAUTION:
Putting the cleaner against the
wall without any other support may cause the
cleaner to fall down, resulting in personal injury
or damage to the cleaner.
Fig.20
Regular maintenance
NOTICE:
Clean the filters in the cyclone unit
when they become clogged. Continuing use in
the clogged condition may result in heating or motor
malfunction.
NOTICE:
Do not blow dust sticking on the
cleaner and filters by air duster. It brings dust into
the housing and causes failure.
Routine maintenance is required to restore normal
operating conditions.
Cleaner body
Wipe off the outside (cleaner body) of the cleaner using
a cloth dampened in soapy water, and clean out the
suction openings.
Fig.21
Publicidad
