Publicidad
Idiomas disponibles
Idiomas disponibles
Cyclone unit and filters
NOTICE:
Dust off and clean out inside the
cyclone unit and filters, when suction perfor-
mance becomes less effective regardless of the
amount of dust collected in the dust case.
NOTICE:
After washing filters, dry them thoroughly
before use. Insufficiently dried filters may cause poor
suction and shorten the service life of the motor.
NOTICE:
After cleaning filters and sponge sheet,
be sure to re-install them before use. If you use the
cleaner without filters and sponge sheet, dust comes
into the motor housing and causes malfunction.
Cyclone unit
1.
Tap the cyclone unit several times with your hand
to remove dust adhering to the inner surface of the
cyclone unit and filter.
Fig.22
► 1 . Cyclone unit
2.
With the suction inlet pointing downwards, turn the
cyclone unit as shown in the figure aligning the pointer
on the cyclone unit with that on the cleaner body to
disengage the lock. Then detach the cyclone unit from
the cleaner body slowly and straightly.
1
2
Fig.23
► 1 . Cyclone unit 2. Suction inlet 3. Pointers 4. Filter
NOTE: Dust may fly out when the cyclone unit is
disassembled. It is recommended to place a garbage
bag underneath the cyclone unit.
3.
Fig.24
4.
aligning the pointer on the cyclone unit with that on the
cleaner body. Then turn the cyclone unit as shown in
the figure until it is secured in place.
1
Fig.25
► 1 . Cyclone unit 2. Cleaner body 3. Pointers
4
3
12 ENGLISH
Dust off inside the cyclone unit and filter.
Place the cyclone unit back onto the cleaner body,
1
3
2
Publicidad
