Maytag Precision Touch 850 Serie Guía De Uso Y Cuidado página 26

Troubleshooting
Oven will not self-clean. Check to make sure the cycle is not set for a delayed start. See pages 18-19.
Check if door is closed.
Check if control is in Sabbath Mode. See page 15.
Oven may be over 400° F. Oven temperature must be below 400 ° F to program a
clean cycle.
Oven did not clean properly. Longer cleaning time may be needed.
Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
Oven door will not unlock after Oven interior is still hot. Allow about one hour for the oven to cool after the
self-clean cycle, completion of a self-clean cycle. The door can be opened when tile LOCK indicator
word is not displayed.
• The control and door may be locked. See page 9.
Moisture collects on oven window • This is normal when cooking foods high in moisture.
or steam comes from oven vent. Excessive moisture was used when cleaning the window.
There is a strong odor or light • This is normal for a new range and will disappear after a few uses. Initiating a clean
smoke when oven is turned on. cycle will "burn off" the odors more quickly.
• Turning on a ventilation fan will help remove the smoke and/or odor.
Excessive food soils on the oven bottom. Use a self-clean cycle.
Fault Codes
Noises may be heard.
There are no beeps and
no display.
BAKE or LOCK may flash rapidly in the display to alert you if there is an error
or a problem. If BAKE or LOCK appear in the display, press the CANCEL pad.
If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a
few minutes, and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized servicer.
If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
• The oven makes several low level noises. You may hear the oven relays as they go on
and off. This is normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
Oven may be in Sabbath Mode. See page 15.
25