Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALL GLASS PANEL (SBN
The SBN hood models decorative glass panel is sold separately and has to be installed before completing the hood installation.
1. Using a Robertson or a Phillips no. 2 screwdriver, remove the 5 screws retaining the
electrical compartment cover. Set cover and screws aside.
2. Carefully remove the glass panel from its packaging. Remove glass panel nuts
(factory installed) from both studs and set aside.
3. Insert glass panel studs in the appropriate hood holes.
4. While holding the glass panel, pre-tighten the previously removed nuts by hand.
Make sure the glass panel is centered. Then, using a 3/8" socket, tighten the
nuts completely.
5. Reinstall the electrical compartment cover.
6. PREPARE THE OPENING
Never use a hammer and screwdriver to remove the vertical or horizontal discharge knock-out; this would damage
the hood internal parts.
V
ERTICAL DISCHARGE
Using long nose pliers, remove the knock-out located on the top of the
hood.
See illustrations at right.
H
ORIZONTAL DISCHARGE
Using long nose pliers, remove the knock-out located at the back of the
hood.
See illustrations at right.
)
MODELS ONLY
CAUTION
HR0068
6
S
HD0560
G
LASS PANEL STUD
HD0561
V
:
ERTICAL DISCHARGE
1
H
:
ORIZONTAL DISCHARGE
1
CREW LOCATIONS
N
UT
2
2
Publicidad
