Husqvarna 535i XP Manual Del Usuario página 17

suddenly and with large force, which throws the product,
guide bar and saw chain against the operator.
Kickback always occurs in the cutting plane of the guide
bar. Usually, the product, guide bar and saw chain are
thrown against the operator but can also move in a
different direction. It is how you use the product when
the kickback occurs that causes the direction of
movement.
Kickback only occurs if the kickback zone of the guide
bar touches an object. Do not let the kickback zone
touch an object.
The smaller the bar tip radius the lower the risk of
kickback.
A saw chain is made up of a number of links, which are
available as standard and low kickback. You can
decrease the effects of kickback by using the correct
cutting equipment with kickback reduction.
WARNING: No saw chain fully prevents the
dangerous situations that can occur during a
kickback.
958 - 001 - 16.11.2018
Common questions about kickback
• Will the hand always engage the chain brake
during a kickback?
No. It is necessary to use some force to push the
front hand guard forward. If you do not use the force
necessary, the chain brake may not be engaged.
This can occur if your hand only lightly touches the
front hand guard. You must also hold the handles of
the product stable with two hands during work. If a
kickback occurs, your hand may not let go of the
front handle. Then it will not engage the chain brake,
or the chain brake will only engage after the product
has moved around a large distance. If this situation
occurs, the chain brake may not stop the saw chain
before it touches you. There are also some positions
in which your hand can not touch the front hand
guard to engage the chain brake. An example of this
is in the felling position.
• Will the inertia release mechanism always
engage the chain brake during kickback?
No. First, the chain brake must work correctly. See
Maintenance and checks of the safety devices on
the product on page 23 for instructions about how
to do a check of the chain brake. We recommend
you to do this each time before you use the product.
Second, the kickback must be intense to engage the
chain brake. If the chain brake is too sensitive it will
be engaged all the time.
• Will the chain brake always protect me from
injury during a kickback?
No. The chain brake must work correctly in order to
give the correct protection. The chain brake must
also be engaged during a kickback to stop the saw
chain. If you are near the guide bar, the chain brake
may not have time to stop the saw chain before it
hits you.
WARNING: Only you and the correct
working technique can prevent kickbacks.
To use the cutting technique
WARNING: Use full power when you cut
and decrease the speed to idle after each
cut.
CAUTION: Motor damage can occur if the
motor runs for too long at full power without
load. For example if the motor runs for too
long without resistance from the saw chain
during cutting.
You can use the product to cut through wood in two
different positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
17