Husqvarna 535i XP Manual Del Usuario página 26

To sharpen the saw chain
Information about the guide bar and saw
chain
Replace a worn or damaged guide bar or saw chain with
the guide bar and saw chain combinations
recommended by Husqvarna. This is important in order
to keep the safety functions of the cutting equipment.
Accessories on page 34 , for a list of replacement
See
bar and chain combinations that we recommend.
• Length, in/cm.
• Number of teeth on bar tip sprocket (T).
• Chain pitch, in. The distance between the drive links
of the saw chain must align with the distance of the
teeth on the bar tip sprocket and drive sprocket.
• Number of drive links. The number of drive links is
decided by the length of the bar, the chain pitch and
the number of teeth on the bar tip sprocket.
26
L
D
PITCH =
2
D
• Bar groove width, in/mm. The groove in the guide
bar must align with the width of the chain drive links.
• Chain oil hole and hole for chain tensioner. The
guide bar must align with product.
• Drive link width, mm/in.
General information about how to sharpen
the cutting teeth
Do not use a blunt saw chain. If the saw chain is blunt,
you must apply more pressure to push the guide bar
through the wood. If the saw chain is very blunt, there
will be no wood chips but sawdust.
A sharp saw chain eats through the wood and the wood
chips becomes long and thick.
The cutting tooth (A) and the depth gauge (B) together
makes the cutting part of the saw chain, the cutter. The
difference in height between the two gives the cutting
depth (depth gauge setting).
When you sharpen a cutting tooth, think about the
following:
A
B
958 - 001 - 16.11.2018