Husqvarna 535i XP Manual Del Usuario página 9

Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. Refer to
Maintenance and checks of the safety devices on
the product on page 23 .
• If the safety devices are defective, speak to your
Husqvarna servicing dealer.
Keypad
The warning indicator flashes if the chain brake is
engaged or if there is a risk of overload. The overload
protection temporarily stops the product and you can not
use the product until the temperature restores. If the
indicator shows a solid light, turn to your servicing
dealer.
The automatic stop function
The product has an automatic stop function that stops
the product if you do not use it for one minute.
Chain brake and front hand guard
Your product has a chain brake that stops the saw chain
if you get a kickback. The chain brake decreases the
risk of accidents, but only you can prevent them.
958 - 001 - 16.11.2018
WARNING: Do not engage in situations
where there is a risk of kickback. Be careful
when you use your product and make sure
that the kickback zone of the guide bar does
not touch an object.
The chain brake engages (A) manually by your left hand
or automatically by the inertia release mechanism. Push
the front hand guard (B) forward to engage the chain
brake manually. This movement starts a spring-loaded
mechanism that stops the drive sprocket.
How the chain brake is engaged depends on the force of
the kickback. It also depends on the position of the
product when the kickback zone hits an object. If you get
a intense kickback while the kickback zone is farthest
away from you the chain brake engages by the inertia
release. If the kickback is small or the kickback zone is
nearer you the chain brake engages manually by your
left hand.
Use the chain brake as a parking brake when you start
the product and when you move short distances. This
B
A
9