Drilling With The Machine - BDS Maschinen MAB 1300 Instrucciones De Manejo

O p e r a t i o n
D r i l l i n g w i t h t h e m a c h i n e
D r i l l i n g w i t h t w i s t d r i l l s
2 6
When drilling with twist drills, proceed as follows:
Remove the tool holder with the retainer .
‹
Push twist drills with MK taper from below into the morse
‹
taper (5) of the machine .
Push twist drills with straight shank into the drill chuck after
‹
fitting the drill chuck.
Place the machine at the working location, align it and switch
‹
on the magnetic clamps .
Select a suitable speed and switch on the machine .
‹
NOTE
Observe the following instructions when drilling with twist drills:
► Under excessive pressure, the drill can wear out and the
machine can be overloaded .
► Pay attention to the production of shavings . In the case of
larger drilling depths, break shaving regularly .
M A B 1 3 0 0